Master Cylinder Replacement

Master Cylinder Replacement

Caution: Refer to Brake Fluid Irritant Caution.

Notice: Refer to Brake fluid Effects on Paint and Electrical Components Notice.

Removal Procedure





1. Disconnect the electrical connector from the brake fluid level sensor.
2. Disconnect the brake pipes from the master cylinder.

Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and contamination.

3. Plug the open brake pipe fitting ends.
4. Remove the 2 master cylinder mounting nuts.
5. Remove the master cylinder.
6. Remove the reservoir from the master cylinder if it is to be reused on a replacement master cylinder.

Installation Procedure





1. Install the brake master cylinder reservoir to the master cylinder if it was removed previously.
2. Bench bleed the master cylinder.
3. Install the master cylinder to the vacuum brake booster.

Notice: Refer to Fastener Notice.

4. Install the brake master cylinder mounting nuts.
^ Tighten the brake master cylinder mounting nuts to 25 Nm (18 ft. lbs.).
5. Remove the plugs from the brake pipes.
6. Install the brake pipes to the master cylinder.
^ Tighten the brake pipe fittings at the master cylinder to 32 Nm (24 ft. lbs.).
7. Connect the electrical connector to the brake fluid level sensor.
8. Bleed the hydraulic brake system.