Operation CHARM: Car repair manuals for everyone.

Replacement procedure



BATTERY NEGATIVE CABLE REPLACEMENT

REMOVAL PROCEDURE

IMPORTANT:
- Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
- Always route the replacement cable the same way as the original cable.

1. Disconnect the battery negative cable.




2. Disconnect the body harness from the battery negative cable.
3. Disconnect the battery negative cable from the floor pan.
4. Remove the battery negative cable from the vehicle.

INSTALLATION PROCEDURE




1. Connect the body end of the battery negative cable to the floor pan.

Tighten the battery negative cable to floor pan bolt to 36 N.m (27 lb ft).

NOTE: Refer to Fastener Notice in Service Precautions.

IMPORTANT: When installing the battery negative cable, be sure that the cable eyelet is installed with the flat side down. Keep the crimped side facing upward.

2. Connect the body harness connector to the body harness.
3. Connect the battery negative cable.