Memory Seat Module Replacement

SEAT CONTROL MODULE REPLACEMENT - REAR NO. 2

REMOVAL PROCEDURE
1. Remove the seat cushion frame.




2. Disconnect the electrical connector (1) from the seat control module.
3. Remove the nuts from the control module (2).
4. Remove the module.

INSTALLATION PROCEDURE
1. Install the seat control module on to seat adjuster.




2. Install the seat control module nuts (2).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 9 N.m (80 lb in).

3. Connect the electrical connector (2) to the control module.
4. Install the seat cushion frame.
5. Calibrate the seat. Refer to Power Folding Seat Calibration.