Generator Bracket

GENERATOR BRACKET REPLACEMENT

REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Remove the generator.
3. Remove the coolant inlet pipe lower bolt from the generator bracket.
4. Remove the belt tensioner.




5. Remove the generator bracket bolts.
6. Remove the generator bracket.

INSTALLATION PROCEDURE




1. Install the generator bracket.
2. Install the generator bracket bolts.

Tighten the bolts in the sequence shown.
1. Tighten the bolts (1, 2) to 50 N.m (37 lb ft).
2. Tighten the bolt (3) to 23 N.m (17 lb ft).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the belt tensioner.
4. Install the coolant inlet pipe lower bolt from the generator bracket.
5. Install the generator.