Ignition Switch: Service and Repair

IGNITION SWITCH REPLACEMENT

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

2. Remove the driver knee bolster trim panel.
3. Remove the driver information center (DIC) switch.




4. Disconnect the ignition switch electrical connector.
5. Remove the ignition switch from the DIC pod.Carefully pull to unsnap.

INSTALLATION PROCEDURE




1. Install the ignition switch into position on the DIC pod.




2. Connect the ignition switch electrical connections.




3. Install the DIC switch pod.
4. Install the driver knee bolter trim panel.
5. Connect the negative battery cable.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the cable bolt to 15 Nm (11 lb ft).