Antenna Replacement - Cellular Communications/Digital Radio

ANTENNA REPLACEMENT - CELLULAR COMMUNICATIONS/DIGITAL RADIO

REMOVAL PROCEDURE




1. Remove the rear sail panels.

NOTE: DO NOT apply paint or clear coat to the antenna. This will damage the function of the antenna, causing poor reception or loss of signal reception.

2. Lower the rear of the headliner.

NOTE: Use care when removing or installing the headliner. Excessive bending will damage the headliner.

3. Remove the foam tape from the antenna cable connection.
4. Disconnect the antenna connectors (1).
5. Remove the antenna bolt (2) and expansion sleeve (3).




6. Remove the antenna.

INSTALLATION PROCEDURE




1. Install the antenna to the roof.




2. Route the wiring pigtail to the side in the slot on the antenna shaft and install the antenna expansion sleeve (3) and bolt (2) to the antenna shaft.

NOTE: Refer to Fastener Notice.

Tighten the bolt to 6 N.m (53 lb in).

3. Connect the antenna connectors (1).
4. Wrap the connectors (1) with foam tape.
5. Install the antenna cable connection above the AM/FM antenna module.
6. Install the antenna cable hold down clips.
7. Align the headliner to the roof panel.
8. Install the rear sail panels.