Oil Pressure Sensor: Service and Repair

Engine Oil Pressure Sensor and/or Switch Replacement

Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.





2. Disconnect the electrical connector (2) from the engine oil pressure switch (1).
3. Remove the engine oil pressure switch (1) from the oil filter adapter (3).

Installation Procedure





1. Notice: Refer to Component Fastener Tightening Notice in Service Precautions.

Install the engine oil pressure switch (1) to the oil filter adapter (3).
Tighten the engine oil pressure switch to 16 Nm (12 ft. lbs.).
2. Connect the electrical connector (2) to the engine oil pressure switch (1).
3. Lower the vehicle.
4. Adjust the engine oil level to the full mark.
5. Inspect for oil leaks after engine start up.