61. Lower Control Valve Body and Internal Mode Switch Installation

Lower Control Valve Body and Internal Mode Switch Installation

^ Tools Required
- J 39630-1 Lower Control/Valve Body Gasket Guide Pins
- J 39630-2 Lower Control/Valve Body Gasket Guide Pins
- DT-47707-R1 Internal Mode Switch Alignment Tool





1. Install the lower control valve body (903) over the J 39630-2.

2. Notice:
Refer to Fastener Notice in Service Precautions.

Position the solenoid valve fluid filter retainer (981) onto the lower control valve body (903) and install some of the valve body bolts (938, 940, 941) and hand tighten them.
3. Remove the J 39630-2.
Tighten the bolts (938, 940, 941) in a star pattern to 8 - 14 Nm (6 - 10 ft. lbs.).





4. Position the DT-47707-R1 onto the lower control valve body, next to the 2-3 shift solenoid valve, and install the two J 39630-1.

5. Important:
Hold the IMS (942) against the DT-47707-R1 while tightening the bolts.

Locate the internal mode switch (IMS) (942) against the DT-47707-R1 and install the three 8 mm bolts (939).
Tighten the bolts (939) to 8 - 14 Nm (6 - 10 ft. lbs.).
6. Remove the DT-47707-R1 and the J 39630-1.





7. Install the remaining bolts (941) into the lower control valve body (903).
Tighten the bolts (941) to 8 - 14 Nm (6 - 19 ft. lbs.).





8. Connect the lower control valve body wire harness (943) to the following parts:
^ 1-2 shift solenoid valve (909)
^ 2-3 shift solenoid valve (910)
^ Internal mode switch (IMS) (942)