Operation CHARM: Car repair manuals for everyone.
Home >> Cadillac >> 2006 >> STS AWD V8-4.6L VIN A >> Repair and Diagnosis >> Body and Frame >> Mirrors >> Service and Repair >> Procedures >> Rearview Mirror Replacement (With RPO code UE1)
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Rearview Mirror Replacement (With RPO code UE1)



REARVIEW MIRROR REPLACEMENT (WITH RPO CODE UE1)

REMOVAL PROCEDURE




1. Disconnect the electrical connector from the back of the mirror.
2. Remove the wire cover.
3. Adjust the mirror to the full upward position.
4. Remove the base trim cover.




5. Loosen the screw (3) in order to remove the mirror (2) from the button assembly (1).
6. Slide the mirror assembly in an upward motion in order to remove.

INSTALLATION PROCEDURE




1. Position the center bottom of the mirror mount against the windshield at the top of the support button (1).
2. Slide the base of the mirror onto the button.
3. Make sure the mirror is firmly seated on the windshield button by pushing down on the base of the mirror.

NOTE: Refer to Fastener Notice.

Tighten the screw (3) to 1.8 N.m (16 lb in) in order to secure the mirror base to the button.

4. Install the base trim cover.




5. Connect the electrical connector.
6. Install the wire cover.
7. Reposition the mirror assembly.
8. Refer to Control Module References for programming and setup information. Programming and Relearning

pro multis · About Operation CHARM