Steering Mounted Controls Assembly: Service and Repair

Steering Wheel Control Switch Assembly Replacement

Removal Procedure






Caution: Refer to Restraint System Service Precautions.

1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the steering wheel inflatable restraint module.
3. Disconnect the electrical connectors for the steering wheel control switch.




4. Remove the retaining screws from the steering wheel control switch.
5. Remove the retainer and screw from the steering wheel control harness.
6. Carefully pull the control switch assembly away from the steering wheel.
7. Remove the control switch assembly from the steering wheel.
8. Remove the wire harness from the control switch assembly.

Installation Procedure

1. Install the wire harness to the steering wheel control switch assembly.




2. Align the control switch assembly engagement tabs to the steering wheel.
Push in on the control switch assembly in order to secure the assembly to the steering wheel.






Notice: Refer to Fastener Notice.

3. Install the control harness retainer and screw.

Tighten the screw to 2.3 N.m (20 lb in).

4. Install the control switch assembly screws

Tighten the screws to 2.3 N.m (20 lb in).




5. Connect the electrical connector to the steering wheel control.
6. Secure the connector to the retaining clip.
7. Install the inflatable restraint module.
8. Enable the SIR. Refer to SIR Disabling and Enabling.