Manifold Pressure/Vacuum Sensor: Service and Repair

Manifold Absolute Pressure Sensor Replacement

Removal Procedure




1. Remove the fuel injector sight shield, if necessary.
2. Disconnect the engine harness electrical connector (4) from the manifold absolute pressure (MAP) sensor.




3. Remove the MAP sensor bracket bolt.
4. Remove the MAP sensor bracket.
5. Remove the MAP sensor.

Installation Procedure




1. Install the MAP sensor.
2. Install the MAP sensor bracket.

Notice: Refer to Fastener Notice.

3. Install the MAP sensor bracket bolt.

Tighten the bolt to 10 N.m (89 lb in).




4. Connect the engine harness electrical connector (4) to the MAP sensor.
5. Install the fuel injector sight shield, if necessary.