Air Cleaner Housing: Service and Repair

Air Cleaner Assembly Replacement

Removal Procedure




1. Remove the air cleaner outlet duct from the vehicle.
2. Disconnect the mass air flow (MAF)/intake air temperature (IAT) sensor electrical connector.
3. Remove the MAF/IAT sensor if necessary.
4. Remove the coolant hose from the retaining feature on the top of the air cleaner assembly. Position the hose aside.




5. Remove the screws securing the air cleaner assembly to the vehicle and remove the assembly.

Installation Procedure

Important: An improperly installed air cleaner or a distorted or missing intake air duct may cause a diagnostic trouble code (DTC) to set. Ensure that the air cleaner assembly and intake air duct is installed correctly and that there are no kinks or folds in the intake air duct. Debris in the air cleaner assembly or MAF sensor inlet screen, that may distort air flow can set a DTC.




1. Install the air cleaner assembly into the vehicle.

Notice: Refer to Fastener Notice.

2. Install the air cleaner assembly screws.

Tighten the air cleaner assembly screws to 10 N.m (89 lb in).




3. Install the coolant hose into the retaining feature on the top of the air cleaner assembly.
4. Install the MAF/IAT sensor if previously removed.
5. Connect the MAF/IAT sensor electrical connector.
6. Install the air cleaner outlet duct.