Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Inflatable Restraint Side Impact Sensor Replacement



Inflatable Restraint Side Impact Sensor Replacement

Removal Procedure

Caution: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

Caution: Refer to Restraint System Service Precautions.

1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Move the seat to the full forward position.
3. Remove the center pillar trim panel.




4. Remove the connector position assurance (CPA) (1) from the harness connector (2) to the inflatable restraint side impact sensor (SIS).
5. Disconnect the harness connector (2) from the SIS (3).




6. Remove the SIS mounting fasteners (2).
7. Remove the SIS (1) from the center pillar.

Installation Procedure




1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Install the SIS (1) to the center pillar.

Notice: Refer to Fastener Notice.

3. Install the SIS mounting fasteners (2).

Tighten the fasteners to 9 N.m (80 lb in).




4. Install the harness connector (2) to the SIS (3).
5. Install the CPA (1) to the SIS harness connector (2).
6. Install the center pillar trim.
7. Move the seat to the original position.
8. Enable the SIR system. Refer to SIR Disabling and Enabling.