Ignition Switch: Service and Repair

IGNITION AND START SWITCH REPLACEMENT

REMOVAL PROCEDURE

1. CAUTION: Refer to Battery Disconnect Caution.

Disconnect the negative battery cable.

2. Remove the driver knee bolster trim panel.
3. Remove the driver information center (DIC) switch.




4. Disconnect the ignition switch electrical connector.
5. Remove the ignition switch from the DIC pod.Carefully pull to unsnap.

INSTALLATION PROCEDURE




1. Install the ignition switch into position on the DIC pod.




2. Connect the ignition switch electrical connections.




3. Install the DIC switch pod.
4. Install the driver knee bolter trim panel.

5. NOTE: Refer to Fastener Notice.

Connect the negative battery cable.

Tighten the cable bolt to 15 N.m (11 lb ft).