Steering Column Trim Covers Replacement

Steering Column Trim Covers Replacement

Removal Procedure

Caution: Refer to Restraint System Service Precautions.

1. Disable the SIR system. Refer to SIR Disabling and Enabling.
Caution: Refer to Battery Disconnect Caution.

2. Disconnect the battery negative cable.
3. Remove the steering wheel.
4. Remove the knee bolster.




5. Remove the retaining screws (4) from the lower steering column trim cover.
6. Disconnect the closeout shroud from the lower trim cover.

Notice: Avoid damaging the steering column electronic lock harness by gently removing the plugs installed in the I/P beam. Do NOT twist, pull, bend, cut, or incorrectly route the harness. Damage to the harness will require replacement of the entire electronic lock.

7. Disconnect the electrical connector for the power tilt and telescopic switch.
8. Remove the electrical connector for the telescopic switch from the lower trim cover.




9. Remove the retaining screw (2) from the upper steering column trim cover (1).
10. Remove the upper trim cover.
11. Remove the closeout shroud from the upper trim cover.

Installation Procedure




1. Install the upper steering column trim cover (1) to the closeout shroud (3).
2. Install the upper trim cover (1) to the steering column.

Notice: Refer to Fastener Notice.

3. Install the retaining screw to the upper trim cover.

Tighten the screw to 1 N.m (9 lb in).




4. Install the lower steering column trim cover and ensure that the tabs (2) on the lower trim cover engage with the tabs on the upper trim cover. Snap the covers together.
5. Connect the lower trim cover to the closeout shroud.
6. Install the retaining screws to the lower trim cover.

Tighten the screws to 3 N.m (27 lb in).

Notice: Avoid damaging the steering column electronic lock harness by gently removing the plugs installed in the I/P beam. Do NOT twist, pull, bend, cut, or incorrectly route the harness. Damage to the harness will require replacement of the entire electronic lock.

7. Install the knee bolster.
8. Install the steering wheel.
9. Connect the battery negative cable.
10. Enable the SIR system.