Sunroof / Moonroof Motor: Service and Repair

Sunroof Motor/Actuator Replacement

Removal Procedure

Important: Do not apply battery voltage to a new sunroof motor/actuator prior to installing the motor/actuator to the sunroof module assembly.



The sunroof window must be in the full closed position.

1. If possible, close the sunroof window before removing the sunroof motor/actuator.
2. Lower the headliner at the rear in order to gain access to the sunroof motor/actuator. Refer to Headlining Trim Panel Replacement (Service and Repair) .




3. Disconnect the electrical connectors (3) from the sunroof motor/actuator (1).
4. Remove the bolts (5) attaching the sunroof motor/actuator (1) to the sunroof module assembly (2).
5. Remove the sunroof motor/actuator from the sunroof module assembly (2).



Installation Procedure





1. Manually move the sunroof window to the full closed position.
2. Install the sunroof motor/actuator (1) to the sunroof module assembly (2).

Notice: Refer to Fastener Notice .

3. Install the bolts (5) attaching the sunroof motor/actuator to the sunroof module assembly.

Tighten the bolts to 5 N.m (44 lb in).

4. Connect the electrical connectors (3) to the sunroof motor/actuator (1).

Important: Verify the sunroof operation before installing the headliner.


5. Check the sunroof window to the roof opening fit. Refer to Sunroof Window Height and Opening Fit Adjustment (Adjustments) .
6. Install the headliner. Refer to Headlining Trim Panel Replacement (Service and Repair) .