Operation CHARM: Car repair manuals for everyone.
Home >> Cadillac >> 2008 >> STS RWD V6-3.6L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Sensors and Switches - Computers and Control Systems >> Fuel Tank Pressure Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Fuel Tank Pressure Sensor: Service and Repair



Fuel Tank Pressure Sensor Replacement

Removal Procedure





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service Intervals) .
2. Disconnect the fuel tank pressure sensor electrical connector (1).





Important: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.


3. Remove the fuel tank pressure sensor from the evaporative emission (EVAP) canister.



Installation Procedure






Important: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.


1. Install the fuel tank pressure sensor to the EVAP canister until fully seated.




2. Connect the fuel tank pressure sensor electrical connector (1).
3. Lower the vehicle.


pro multis · About Operation CHARM