Front Drive Axle

Front Axle Lubricant Level Inspection (9.25 Inch Axle)

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Make sure the vehicle is level.
3. Inspect the front axle for leaks. Repair as necessary.
4. Clean the area around the front axle fill plug.




5. Remove the front axle fill plug (1).
6. Inspect the oil level.

The 9.25 inch axle the oil level should be between 0-6 mm (0-0.25 in) below the fill plug opening.

7. If the level is low, add oil until the level is between 0-6 mm (0-0.25 in) for the 9.25 inch axle. Use the correct fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers ().

Caution: Refer to Fastener Caution (Fastener Caution).

8. Install the fill plug and tighten to 33 Nm(24 lb ft).
9. Lower the vehicle.