Front Axle Vent Hose Connector Replacement (9.25 Inch Axle)

Front Axle Vent Hose Connector Replacement (9.25 Inch Axle)

Removal Procedure

1. Raise the vehicle. Refer Lifting and Jacking the Vehicle (Service and Repair).




2. Disconnect the vent hose from the vent hose connector.




3. Remove the vent hose connector from the differential carrier assembly.

Installation Procedure




1. Install the vent hose connector into the differential carrier assembly.
Apply a small amount of sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent onto the threads.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the vent hose connector and tighten to 28 Nm (21 lb ft).




3. Connect the vent hose to the vent hose connector.
4. Lower the vehicle.