113. Cylinder Head Installation - Right Side

Cylinder Head Installation - Right Side (LAU or LBW)

Special Tools

EN 45059 - Angle Meter

For equivalent regional tools, refer to Special Tools (Special Tools).




1. Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face.
Install a NEW cylinder head gasket bank 1 using the deck face locating pins for retention.




2. Align the cylinder head bank 1 with the deck face locating pins.
3. Place the cylinder head bank 1 in position on the deck face.

Right Sequence:

Caution: Refer to Fastener Caution (Fastener Caution).

Note:
* DO NOT allow oil on the cylinder head bolt bosses.
* DO NOT reuse the old cylinder head bolts.

4. Install the NEW M11 cylinder head bolts (1).

1. Tighten the M11 cylinder head bolts a first pass in sequence to 30 Nm (22 lb ft).
2. Tighten the M11 cylinder head bolts a second pass in sequence an additional 150 degrees using the EN 45059 - meter.

5. Install the NEW M8 cylinder head bolt (2).

1. Tighten the M8 cylinder head bolt a first pass to 15 Nm (11 lb ft).
2. Tighten the M8 cylinder head bolt a second pass an additional 75 degrees using the EN 45059 - meter.