Battery Negative Cable Disconnection and Connection

Battery Negative Cable Disconnection and Connection

Removal Procedure




Warning: Refer to Battery Disconnect Warning Service Precautions.

1. Remove the engine control module (ECM) from on top of the battery cover and set aside.
2. Remove the battery cover retaining tabs (1) and remove the battery cover (2).




3. Loosen the battery negative cable clamp fastener (1) and remove the battery negative cable (2).

Installation Procedure





Caution: Refer to Fastener Caution Fastener Caution.

1. Install the battery negative cable (2) to the battery negative post and tighten the clamp fastener (1) to 9 Nm (80 lb in).




2. Install the battery cover (2) to the battery tray with the retaining tabs (1).
3. Install the ECM to the top of the battery cover.