Auxiliary Battery Positive Cable Replacement

Auxiliary Battery Positive Cable Replacement

Removal Procedure




1. Remove the battery fuse block cover (1).
2. Disconnect the negative battery cable.Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection
3. Remove the auxiliary battery positive terminal nut (2) from the fuse block.




4. Remove the nut (1) from the rear of the generator
5. Remove the nut (2) from the starter solenoid.
6. Remove the auxiliary battery positive cable from the vehicle.

Installation Procedure





Caution: Refer to Fastener Caution Fastener Caution.

1. Install the auxiliary battery positive cable nut (2) to the fuse block.Tighten to 15 Nm (11 lb ft).




2. Install the auxiliary battery positive terminal nut (1) to the back of the generator.Tighten to 15 Nm (11 lb ft).
3. Install the auxiliary battery positive terminal nut (2) to the starter solenoid.Tighten to 15 Nm (11 lb ft).
4. Connect the negative battery cable.Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection