Electronic Brake Control Module: Testing and Inspection

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:

* EBCM Reprogramming-Refer to Service Programming System (SPS) Service Programming System (SPS).

* Recalibrate the brake pedal position (BPP) sensor (Without JL7). Refer to Brake Pedal Position Sensor Replacement Service and Repair.

* Steering Angle Sensor (SAS) calibration. Refer to Steering Angle Sensor Centering Procedures.