Throttle Position Sensor: Adjustments

NOTE: Do not remove plug sealing TPS adjustment or adjust TPS unless carburetor is overhauled or "Computer Command Control (C3)" system diagnosis indicates a problem with the switch.

1. Drill a 5/64 inch hole, 1/16 to 1/8 inch deep, in plug covering TPS adjustment screw.
2. Thread a small slide hammer or equivalent into plug and remove plug from air horn.
3. Disconnect TPS connector and jumper all three terminals.
4. Connect digital voltmeter J-29125-A or equivalent to center and bottom terminals of connector.
5. With ignition On and engine Off, turn TPS adjusting screw to obtain .26 volts.
6. Turn ignition Off and install a new plug over TPS adjusting screw or seal opening with RTV sealer.