Starter Motor: Service and Repair
If shims are used between starter and engine block, they should be placed in their original location during installation. If starter is noisy during cranking, remove one .015 inch double shim or add one .015 single shim to the outer bolt. If starter makes a high pitched whine after firing, add .015 inch double shims until noise ceases.
1. Disconnect battery ground cable.
2. Raise and support vehicle.
3. Remove starter to engine brace and starter heat shields, if equipped.
4. Remove starter mounting bolts and lower starter. Note position of shims, if used.
5. Disconnect solenoid wires and the battery cable.
6. Remove starter from vehicle.
7. Reverse procedure to install.