Cleaning and Inspection

Transmission Case

1. Wash the transmission thoroughly inside and outside using a suitable solvent, then inspect the case for cracks. The magnetic disc is glued in place, wipe with clean cloth.
2. Check the front and rear faces for burrs and if present, dress them off with a find mill file.

Roller Bearings and Spacers

1. All bearing rollers should be inspected closely and replaced if they show wear. Replace all worn spacers.

Front and Rear Bearings

1. Wash the front and rear ball bearings thoroughly in a cleaning solvent.
2. Blow out bearings with compressed air.

Notice: Do not allow the bearings to spin. Turn them slowly by hand. Spinning bearings may damage the race and balls.

3. Lubricate bearings with a light engine oil and check them for roughness by slowly turning the race by hand.

Gears

1. Inspect all gears for excessive wear, chips or cracks and replace any that are worn or damaged.
2. Check clutch sleeves to see that they slide freely on their hubs.