Engine: Service and Repair

1. Disconnect battery cables.
2. Remove hood.
3. Remove battery and tray.
4. Remove air cleaner.
5. Drain cooling system and disconnect radiator hoses at engine.
6. Disconnect cooling fan wires.
7. Remove radiator and fan as an assembly.
8. Disconnect fuel lines at fuel pump.
9. Disconnect heater hoses at engine.
10. Disconnect vacuum hoses.
11. Disconnect brake booster vacuum hose at intake manifold.
12. Disconnect accelerator cable from carburetor.
13. Disconnect speedometer cable from transmission.
14. Disconnect outside air duct.
15. Disconnect clutch cable and bracket from transmission.
16. Disconnect wiring harnesses at engine and transmission.
17. Remove A/C compressor adjusting bolt, if equipped.
18. Remove drive belt splash shield.
19. Raise and support vehicle.
20. Disconnect exhaust pipe from manifold.
21. Loosen A/C compressor pivot bolt, if equipped.
22. Remove A/C compressor drive belt, if equipped.
23. Remove A/C compressor bracket from engine, if equipped.
24. Disconnect gearshift control shaft from transmission.
25. Disconnect gearshift extension rod from transmission.
26. Disconnect ball joints.
27. Drain transaxle.
28. Remove drive axles from transaxle.
29. Drain engine oil.
30. Disconnect engine torque rods.
31. Remove transmission mount nut.
32. Lower vehicle.
33. Remove engine side mount.
34. Remove engine mount nuts.
35. Using suitable hoist, remove engine and transaxle as an assembly.
36. Reverse procedure to install.