ECM Power Circuits

Fig. 28 ECM power circuit test connections:

The ignition coil, solenoids and solenoid valves are all connected to the ECM. A loose or open connection in any of these circuits will cause a loss of signal to the ECM, thus causing the system to malfunction. Check all power circuits as follows:
1. Disconnect ECM connector.
2. Turn ignition on without starting engine.
3. Connect voltmeter between terminal 2 of ECM connector and body, Fig. 28, and measure voltage. Voltage should be 12 volts. Repeat with terminals 3, 9, 12, 16, and 18.
4. Connect voltmeter between terminal 13 of ECM connector and body. Voltage should be 12 volts. Depress clutch pedal. Voltage should drop to zero. If not check wiring.
5. Reconnect ECM connector securely.