Fuel Filter: Service and Repair

NOTE: Before replacing a fuel filter it is necessary to relieve fuel system pressure, see MAINTENANCE PROCEDURES/FUEL SYSTEM PRESSURE RELIEF.

REMOVAL:

The fuel filter is located under the rear of the car, by the fuel tank.

WARNING: To reduce the risk of fire and personal injury when the fuel line is disconnected, cover the fuel line with a shop cloth to collect the fuel, and then place the cloth in an approved container.

1. Raise car on hoist.
2. Disconnect the fuel lines from the filter.
NOTE: Use a back-up wrench to prevent filter, "O" ring, or fuel line damage.
3. Remove the filter from the car.

INSTALLATION:

1. Install the new filter in position loosely.
2. Using new "O" rings, install the fuel lines into the filter.
NOTE: Use a back-up wrench to prevent filter, "O" ring, or fuel line damage.
3. Torque line fittings to specification 30 Nm (22 lb.ft).
4. Secure the filter to the car.
5. Lower the car.
6. START the engine and inspect for leaks.