Ignition Lock Cylinder - On Vehicle

Removal

Note: Disable the (SIR) system. See Restraint Systems.

1. Steering wheel assembly.
2. Negative battery cable.
3. Coil assembly retaining clip.
4. Coil assembly off shaft end letting coil hang freely.
5. Wave washer.
6. Spacer shaft lock (standard column only).
7. Shaft lock retaining ring using J 23563-C to compress shaft lock.
8. Pry off retaining ring.
9. Shaft lock.
10. Turn signal canceling cam assembly.
11. Upper bearing spring.
12. Turn signal to right turn position.
13. Multifunction lever. Refer to "Multifunction Turn Signal Lever" in this section.
14. Hazard knob assembly.
15. Screw and signal switch arm.

Note: Let switch arm hang freely (tilt option equipped with cruise control only).

16. Screws for turn signal switch.

Note: Let turn signal switch hang freely.

17. Buzzer switch assembly. Refer to "Buzzer Switch Assembly".
18. Retaining screw.

Important: Cylinder lock must be in lock position.

19. Cylinder lock.

Installation

Note: Ensure all fasteners are securely seated before applying needed torque. Failure to do so may result in component damage or malfunctioning of steering column.

1. Cylinder lock.
2. Cylinder lock retaining screw.
Tighten screw to 4.5 N.m (40 Lbs. In.)
3. Key in "RUN" position.
4. Buzzer switch.
5. Turn signal switch assembly.
Tighten
Screws to 3.4 N.m (30 Lbs. In.)
6. Signal switch arm (tilt steering column only).
Tighten screw to 2.3 N.m (20 Lbs. In.)
7. Hazard knob assembly.
8. Multifunction lever. "
9. Upper bearing spring.
10. Turn signal canceling cam assembly.
Lubricate with grease, synthetic (service kit).
11. Shaft lock.
Inspect shaft lock retaining ring for damage or deformation. Replace with new retaining ring.
12. Shaft lock retaining ring. Line up to block tooth on shaft using J 23632-C to compress shaft lock.
13. Spacer shaft lock (standard column only).
14. Wave washer.
15. Ensure coil assembly is centered.

Important: Coil assembly will become un-centered if: Steering column is separated from steering gear and allowed to rotate or centering spring is pushed down, letting hub rotate while coil is removed from steering column.
16. Coil assembly using horn tower on canceling cam assembly inner ring and projections on outer ring if alignment.
17. Coil assembly retaining ring.
Ring must be firmly seated in groove on shaft.

Important: Gently pull lower coil assembly wire to remove any wire kinks that may be inside column.
18. negative battery cable.
19. Steering wheel assembly.