Cam Unit Assembly 9-1/2 Inch

INSTALL OR CONNECT
1. Cam plate (16) to the side cam gear (21).
2. Wave washer.
3. Clutch plates.





- Alternate the plates.
4. Thrust sleeve (14).
- Press the thrust sleeve flush with the side gear disc splines.
5. Guide clips (20) to the clutch plates.
- Use grease in the clips to hold them in place on the plates.
- If the side cam gear or side thrust sleeve has been replaced, measure and record the overall length of the gear assembly from the front of the gear to the back of the side thrust sleeve (14) including the side gear thrust washer (13).
- Compare this reading with the reading obtained earlier.
- If the new reading is more than 0.0762 mm (0.003 inch) higher or lower than the original, select a thrust washer that will return the reading closest to the original reading.