Troubleshooting Hints - Power Windows

Perform before beginning System Diagnosis
1. Check Circuit Breaker 12.
2. Check that ground G300 is clean and tight.
3. If a motor's internal circuit breaker trips, it will not reset until voltage is removed from the motor.
^ Refer to Doors for Door access. Doors
^ Refer to System Diagnosis. System Diagnosis - Power Windows
^ Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove "GOOD" in a continuity/voltage check (Refer to "Diagnostic Aids/General Troubleshooting Procedures,"). Diagnostic Aids
^ check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems (Refer to "Diagnostic Aids/General Troubleshooting Procedures,"). Diagnostic Aids