Ignition Coil: Service and Repair

REMOVE OR DISCONNECT
Make sure the ignition switch is "OFF."

1. Wiring connectors at the coil.
2. Coil wire.
3. Studs holding the coil bracket and coil to the manifold.
4. Coil bracket and coil.
^ Drill and punch out the two rivets holding the coil to the bracket.
5. Coil from the bracket.

INSTALL OR CONNECT
A replacement coil kit comes with two screws to attach the coil to the bracket.

1. Coil to the bracket with two screws.
2. Coil and bracket to the intake manifold with studs. Tighten ignition coil hold-down studs to 11 Nm (8 lb. ft.).
3. Coil wire.
4. Wiring connectors.