Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously
Reverse Servo Replacement
REMOVAL PROCEDURE1. Remove the rear servo assembly from the transmission case.
Refer to Rear Servo Assembly Remove/Install as needed.
2. Check the pins. Refer to Low and Reverse Band Servo Pin Check.
3. Disassemble the rear servo accumulator. Refer to Low and Reverse Band Servo Accumulator Assemble.
INSTALLATION PROCEDURE
Refer to the following transmission component locator graphic as needed: Rear Servo Assembly Remove/Install
1. Assemble the rear servo accumulator, if needed. Refer to Low/Reverse Band Servo Accumulator Installation.
2. Install the rear accumulator spring in the case bore.
3. install the following parts:
3.1. A new gasket
3.2. The cover
3.3. The six bolts using a 10-mm socket.
- Tighten the bolts to 24 Nm (18 ft. lbs.).