Blower Motor Resistor: Service and Repair

Heater Module - Disassembled View (1 Of 2):

(2 Of 2):

Remove or Disconnect

1. Negative battery cable.
2. Right sound insulator.
3. Blower motor Refer to Blower Motor and Fan Assembly.
4. Cut portion of dash mat to gain access to the rear resistor screw.
5. Electrical connections at blower resistor.
6. Blower resistor screws and resistor.

Install or Connect

1. Blower resistor and resistor screws.

Tighten
^ Screws to 1 N.m (9 lb in).

2. Replace portion of dash mat cut in removal procedure.
3. Electrical connections at blower resistor.
4. Blower motor.

Tighten
^ Screws to 5 N.m (45 lb in).

5. Right sound insulator.
6. Negative battery cable.

Tighten
^ Bolt to 16 N.m (12 lb ft).