Shaft Seal
Removal ProcedureTools Required
^ J 33942-B Compressor Shaft Seal Remover
1. Remove the clutch assembly.
2. Remove the oil felt and the retainer from the compressor drive shaft bore using a flat screwdriver.
3. Remove the key from the drive shaft.
4. Remove the seal snap ring (1) using snap ring pliers.
5. Insert the J 33942-B into the seal.
6. Turn the J 33942-B until the tool makes contact with the seal notches.
7. Pull the seal away from the compressor. Discard the seal.
Installation Procedure
Tools Required
^ J 33942-B Compressor Shaft Seal Remover
^ J 34614 Compressor Shaft Seal Protector
1. Slide the J 34614 onto the compressor drive shaft.
2. Lubricate the new seal with 525 viscosity mineral oil.
3. Engage the J 33942-B to the seal notches.
4. Slide the seal (1) onto the compressor drive shaft.
5. Install the new seal snap ring using snap ring pliers.
6. Install the key into the drive shaft groove.
7. Install the new oil felt and the retainer inside the bore
8. Install the clutch assembly.