Control Assembly Bulb Replacement

Control Assembly Bulb Replacement


REMOVAL PROCEDURE




1. Remove the control assembly.
2. Pull the control assembly out far enough in order to reach the control assembly lamp bulb socket.

Heater Control Vacuum And Electrical Harness:

3. Use the following procedure in order to remove the lamp bulb and the socket:
3.1. Turn the lamp bulb and the socket 1/4 turn.
3.2. Gently lift the lamp bulb and the socket out of the control assembly.
4. Ensure that the control assembly lamp connections are free from the following conditions:
^ Corrosion
^ Damage
5. Clean or replace the connections, as necessary.

INSTALLATION PROCEDURE

Heater Control Vacuum And Electrical Harness:

1. Insert the new lamp bulb and the socket into the control assembly.
2. Secure the new lamp bulb and the socket to the control assembly with 1/4 turn.




3. Install the control assembly.