C0267

Part 1 Of 2:

Part 2 Of 2:

CIRCUIT DESCRIPTION
The pump motor circuit is integral to the BPMV. The EBCM microprocessor energizes the relay within the EBCM in order to supply the battery voltage to the high side of the pump motor. The EBCM microprocessor grounds the low side of the pump motor when activation of the pump motor is required.

CONDITIONS FOR SETTING THE DTC (C0267)
^ The EBCM internal relay is on
^ The pump motor is off
^ Low voltage is present from the low side of the pump motor when high voltage is expected

CONDITIONS FOR SETTING THE DTC (C0268)
^ Vehicle speed is 13 km/h (8 mph)
^ The EBCM internal relay is on
^ The pump motor is commanded ON and then OFF
^ High voltage exists from the low side of the pump motor for 100 ms when the voltage is expected to be low

ACTION TAKEN WHEN THE DTC SETS
^ The ABS indicator lamp turns on
^ The ABS disables

DTCs C0267/C0268 are ignition latched DTCs, which indicates that the above actions remain true until the ignition switch is turned to OFF (even if the cause of the DTC is intermittent).

DTCs C0267/C0268 are DRIP non-critical malfunctions. If another DTC sets before this DTC is investigated and cleared, this will become a DRIP critical malfunction and the BRAKE indicator lamp will also turn on.

For a detailed explanation of malfunction responses, refer to Self-Diagnostics.

CONDITIONS FOR CLEARING THE DTC
^ Repair the conditions responsible for setting the DTC
^ Use the Scan Tool Clear DTCs function

DIAGNOSTIC AIDS
The pump motor is integral with the BPMV. Do not service the pump motor separately. A poor power/ground connection at the 2-way EBCM connector or the 2-way motor harness from the EBCM to the pump motor can cause a DTC C0267. A seized pump motor, shorted pump motor windings or a poor power/ground at the 2-way EBCM connector can cause a DTC C0268. Replace the EBCM or the BPMV if the following tests show that the pump motor EBCM internal circuits have failed.

IMPORTANT: Reset the J 39200 test leads to zero prior to making any resistance measurements. Refer to the J 39200.

TEST DESCRIPTION
The numbers below refer to the steps in the diagnostic table:
3. This step checks for an open pump motor circuit. The pump motor circuit resistance should not be above the 0.5 ohms. Reset the J 39200 test leads to zero prior to making this low resistance measurement.
5. This step determines the resistance of the EBCM ground circuit.
7. This step determines the ignition voltage available to the EBCM.