Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Front

1. Remove the cotter pin.
^ Tighten the hub/rotor bearing nut to 16 Nm (12 ft. lbs.), while turning the wheel forward by hand. This will seat the bearings.

IMPORTANT: Do not back the nut off more than 1/4 turn.

2. Adjust the nut to so that it is just loose. Then, back the nut off until the hole in the spindle aligns with a slot in the nut.
3. Install a new cotter pin.

4. Measure the endplay in the hub/rotor assembly. Proper endplay is 0.03 - 0.20 mm (0.001 - 0.008 inches).