Oil Pressure Sensor: Service and Repair

Removal Procedure

^ Tools Required
- J 41712 Oil Pressure Switch Socket





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the right fender wheelhouse extension. Refer to Wheelhouse Extension Replacement in Body and Frame.
3. Disconnect the engine oil pressure gauge sensor electrical connector (2).





4. Using the J 41712 remove the engine oil pressure gauge sensor.

Installation Procedure

^ Tools Required
- J 41712 Oil Pressure Switch Socket

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the engine oil pressure gauge sensor using the J 41712.
^ Tighten the engine oil pressure gauge sensor to 12 Nm (106 inch lbs.).





2. Connect the engine oil pressure gauge sensor electrical connector (2).
3. Install the right fender wheelhouse extension. Refer to Wheelhouse Extension Replacement in Body and Frame.
4. Lower the vehicle.