Window Handle: Service and Repair
REMOVAL PROCEDURETOOLS REQUIRED
J 9886-01 Door Handle Clip Remover
1. Close the window.
2. Insert the J 9886-01 between the handle and the bearing plate.
3. Align the J 9886-01 with the handle.
4. Push the J 9886-01 in order to disengage the clip.
5. Pull the handle from the door.
6. Remove the window regulator handle from the door.
7. Remove the bearing plate from the door.
INSTALLATION PROCEDURE
1. Install the bearing plate to the door.
2. Install the window regulator handle to the door.
3. Install the retaining clip to the handle.
4. Insert the handle onto the window regulator shaft. Ensure that the handle points toward the front of the door.
5. Push on the handle until the clip engages on the shaft.