Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2000 >> C Tahoe 2WD V8-5.3L VIN T >> Repair and Diagnosis >> Power and Ground Distribution >> Fuse Block >> Service and Repair >> Fuse Block Replacement (IP Wiring Harness Junction Block)
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Fuse Block Replacement (IP Wiring Harness Junction Block)

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.




1. Disconnect the negative battery cable(s).
2. Remove the right side end panel.
3. Unclip the wiring connector(s) from the front of the Instrument Panel (IP) wiring harness junction block Unclip the harness from the fastener.
4. Remove the IP wiring harness junction block from the IP by pressing on both of the clips and pulling rearward.
5. Disconnect the lower IP light bulb by twisting the bulb counter-clockwise and pulling the bulb rearward.
6. Feed the IP wiring harness junction block through the hole in the IP.
7. Disconnect all remaining wiring connectors from the rear of the IP wiring harness junction block.
8. Remove the IP wiring harness junction block from the vehicle.

INSTALLATION PROCEDURE




1. Connect the wiring connectors to the rear of the IP wiring harness junction block.
2. Feed the IP wiring harness junction block through the hole in the IP.
3. Connect the lower IP light bulb by twisting the bulb socket clockwise while pushing in.
4. Connect the IP wiring harness junction block to the IP by pressing on both clips and pushing until sealed.




5. Connect the wiring connector(s) onto the front of the IP wiring harness junction block and connect the harness to the fastener.
6. Install the right side end panel.
7. Connect the negative battery cable(s).
pro multis · About Operation CHARM