Without Traction Control, Electronic

1. Ensure that the cable fitting is snapped onto the throttle lever pin.
2. Ensure that the cable is locked into position on the bracket.
3. Pull the cable adjustment slider on the cable end - rearward until all slack is removed from the cable but without opening the throttle.
4. Push down cable adjustment lock button until it snaps and locks in place.
5. Ensure that the locking tab is secure on both sides.

IMPORTANT: Cable must not have more than 2.0 mm of slack.

6. Excess slack in cable can cause poor performance, such as hesitation on cruise setting.

IMPORTANT: Cable should never be adjusted so tightly that tension from the cable will not allow the throttle to close properly.

7. Pulling cable too tight will prevent engine from returning to idle and could cause unstable idle quality.