Front Caster and Camber Adjustment

- Tools Required
- J38658 Caster/Camber Adjusting Tool
1. Before making any adjustments to the caster or camber, jounce the front bumper three times in order to allow the vehicle to return to the normal height.
2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
3. Loosen the lower control arm nuts.





4. Install the J38658 to the holes in the lower control arm (2) and front crossmember (1).
5. Adjust the camber by rotating the turnbuckle on J38658.
- Rotating the turnbuckle clockwise will increase the camber.
- Rotating the turnbuckle counterclockwise will decrease the camber.





6. Install the J38658 to the holes in the lower control arm (1) and the front crossmember (2).
- Rotating the turnbuckle clockwise will increase the caster.
- Rotating the turnbuckle counterclockwise will decrease the caster.

7. Adjust caster by rotating the turnbuckle on the J38658.
8. Remove the J38658 from the holes.

Notice: Refer to Fastener Notice in Service Precautions.

9. Tighten the lower control arm nuts.
- Tighten the lower control arm nuts to 100 Nm (74 ft. lbs.).
10. Lower the vehicle.