Ignition Control Module: Service and Repair

REMOVAL PROCEDURE
1. Loosen the control module electrical connector bolt.






2. Remove the control module electrical connector from the module.
3. Remove the spark plug wires from the ignition control module.






4. Remove the ignition control module nuts.
5. Remove the engine lift bracket to ignition control module bolt.
6. Remove the ignition control module/coils.
7. Lay the module/coils on a clean work surface.






8. Remove the ignition coil bolts (2) from all the coils (1).
9. Remove the ignition coils (1) from the module (4).
10. Remove the ignition coil seals (3).
11. Remove the module (4) from the module bracket (5).

INSTALLATION PROCEDURE






1. Install the module (4) to the module bracket (5).
2. Install the ignition coil seals (3).
3. Install the ignition coils (1) to the module (4).

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the ignition coil bolts (2).

Tighten
Tighten the ignition coil bolts (2) to 4 N.m (35 lb in).






5. Install the ignition control module/coils.
6. Loosely install the engine lift bracket to ignition control module bolt.
7. Install the ignition control module nuts.

Tighten
^ Tighten the ignition control module nuts to 30 N.m (22 lb ft).
^ Tighten the engine lift bracket to ignition control module bolt to 25 N.m (18 lb ft).






8. Install the spark plug wires to the ignition control module.
9. Install the control module electrical connector to the module.
10. Tighten the control module electrical connector bolt.

Tighten
Tighten the ignition control module bolt to 3 N.m (27 lb in).