Electronic Column Lock Module - Removal

Removal Procedure

- Tools Required
- J 42640 Steering Column Lock Pin

Important: If the steering column connectors are disconnected with the ignition in the ON position, the BCM will enter a fail enable mode and prevent steering column lock operation. The PCM will also inhibit vehicle motion by disabling fuel. To clear the BCM fail enable mode, disconnect the BCM use #25 for 15 seconds.





1. Remove the upper and lower steering column trim covers. Refer to Steering Column Trim Cover Replacement - On Vehicle (Telescoping).
2. Remove the wire harness straps (2) from the steering column tilt head assembly (1) and the column.
3. Install J 42640 to the steering column.
4. Remove the steering column tilt head assembly. Refer to Steering Column Tilt Head Housing - Disassemble - Off Vehicle (Telescoping Column).
5. Remove the electronic column lock module. Refer to Electronic Column Lock Module - Disassemble - Off Vehicle (Telescoping Column).