Ground Strap: Service and Repair

REMOVAL PROCEDURE




1. In order to remove the engine ground strap the battery negative cable is removed from the engine. Some of the vehicle information may get discarded when the battery negative cable is removed. Refer to Battery Negative Cable Disconnect/Connect Procedure for the information that may have to be reset. The battery negative cable does not require disconnection at the battery.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
3. Remove the bolt retaining the battery negative cable and the ground strap to the engine.




4. Remove the bolt retaining the ground strap to the frame.
5. Remove the ground strap.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.




1. Install the bolt and the ground strap to the frame. Align the tab on the ground strap with the hole in the frame.

Tighten
Tighten the ground strap to frame bolt to 25 N.m (18 lb ft).




2. Install the bolt with the battery negative cable and the ground strap to the front of the engine. Align the ground strap in order to avoid contact with the transmission cooler pipes.

Tighten
Tighten the ground strap to engine bolt to 25 N.m (18 lb ft).

3. Lower the vehicle.
4. Reset the vehicle information. Refer to Battery Negative Cable Disconnect/Connect Procedure.