Axle Nut

Important:
^ Adjust the front wheel bearings correctly in order to ensure the front suspension functions properly.
^ The bearings must be a slip fit on the spindle.
^ Lubricate the bearings in order to ensure that the roller bearings will roll and not skid.
^ The spindle nut must have a free-running fit on the spindle threads.

1. With the vehicle raised, tighten the hub/rotor bearing nut to 16 Nm (12 ft. lbs.), while turning the wheel forward by hand.
This will seat the bearings.

Important: Do not back the nut off more than 1/4 turn.

2. Adjust the nut to so that it in just loose. Then, back the nut off until the hole in the spindle aligns with a slot in the nut.
3. Install a new cotter pin.
6.1. Make sure the cotter pin ends do not interfere with the cap.
3.2. Bend the ends of the cotter pin against the nut.
3.3. Cut off any extra pin length.





4. Measure the endplay in the hub/rotor assembly. Proper endplay is 0.03 - 0.20 mm (0.001 - 0.008 inch).