Wheel Alignment Specifications
| Trim Height Specifications (Front) | All Vehicles | Service Checking | 3.74 |
| Service Setting | 3.74 +/- 0.236 | ||
| Side to Side Tolerance | 0.5 | ||
| Trim Height Specifications (Rear) | With Auxiliary Springs | Service Checking | 5.25 +/- 0.5 |
| Service Setting | 5.25 +/- 0.5 | ||
| Side to Side Tolerance | +/- 0.5 | ||
| Without Auxiliary Springs | Service Checking | 4.25 +/- 0.5 | |
| Service Setting | 4.25 +/- 0.5 | ||
| Side to Side Tolerance | +/- 0.5 | ||
| Wheel Alignment Specifications | Caster Note: Caster is relative to the frame, the caster value must be compensated for the measured frame angle. Frame is positive when higher in the rear and negative when lower in the rear. Caster specifications are with respect to a zero frame angle. | Service Allowable | 3.75 +/- 1.0 |
| Service Preferred | 3.75 | ||
| Cross Caster | Service Allowable | 0.00 +/- 0.50 | |
| Service Preferred | 0.00 | ||
| Camber | Service Allowable | 0.50 +/- 0.60 | |
| Service Preferred | 0.50 | ||
| Cross Camber | Service Allowable | 0.00 +/- 0.50 | |
| Service Preferred | 0.00 | ||
| Steering Angle | Service Allowable | -1.0 +/- 3.0 | |
| Service Preferred | - | ||
| Toe | Service Allowable | 0.24 +/- 0.20 | |
| Service Preferred | 0.24 |