Theft Deterrent Re-Learn W/O Scan Tool Or Techline Equipment

This procedure takes approximately 30 minutes. Make sure the battery is fully charged before proceeding.
1. Turn the ignition switch off.
2. Turn the ignition switch all the way from the off to the start position, then leave it in the on position.

NOTE: The engine will not crank.

3. The SECURITY will come on and stay on for at least 10 minutes.
4. Turn the ignition switch off for five seconds.
5. Repeat steps 2, 3, and 4 again for a second time.
6. Repeat steps 2, 3, and 4 again for a third time.
7. Turn the ignition switch off.
8. Turn the ignition switch all the way to the start position. The engine should now start.
9. Check for BCM Diagnostic Trouble Codes (DTCs).